Advancing wind-turbine technology & drivetrains
- Jun 12, 2019 12:32 pm GMT
- 157 views
The Department of Energy (DOE) is funding four projects to develop high-efficiency, lightweight wind turbine generators, all of which are developing direct-drive technologies. Two of these generators are superconducting and do not use permanent magnets or rare earth materials.
Regardless of whether its direct drive or geared, these components are massive (200320 tons for a 10-MW turbine generator system, and as they are positioned on the top of the wind turbines tower, this also increases the weight and cost of the tower and foundation. They also require large, expensive cranes for installation, and have transportation constraints due to their weight.
The drivetrain is the powerhouse of a wind turbine, containing the generator and gearbox which converts the torque or rotation of the bladesinto electricity. Most wind-turbine drivetrains currently use generators that are connected to gearboxes, which speed up the rotation from the relatively slow speed of the turbines blades (typically 5 to 15 rotations per minute for a modern machine), to the high speeds (1,000 to1,800 rotations per minute) needed to generate electricity using a high-speed induction generator.
Having all of those moving parts makes the gearbox one of the highest-maintenance parts of a wind turbine. One alternative is to use a direct-drive generator that can generate electricity at much lower speeds.
Direct-drive systems do not require a gearbox and therefore have fewer moving parts. However, they usually use permanent magnets, which require expensive, heavy, rare earth materials such as neodymium and dysprosium, and they typically require heavier generators than geared machines for a given turbine capacity. Wind-turbine tower heights have grown from 60 to over 80 meters, and are expected to exceed 100 meters (330 feet) in the coming years, adding to these challenges.
At the same time, average wind turbine capacities have increased from 1 MW to 2 to 3 MW on land and 5 to 6-MW offshore, with plans for 10 to 12-MW offshore wind turbines by the mid-2020s. This increase in capacity means more powerful machines that can generate more electricity, but it also means larger and heavier components.