The Energy Collective Group

This group brings together the best thinkers on energy and climate. Join us for smart, insightful posts and conversations about where the energy industry is and where it is going.

9,995 Members

Post

Getting the Salt Out

Water produced from an operating oil or gas well, usually very salty after contacting underground rocks, can be cleaned of its salts and other contaminants using electrodialysis, and then reused to reduce the amount of freshwater needed. This diagram illustrates the process, with salty water in dark blue and fresh water in light blue. The electrodialysis process, using membranes and electric charges, is illustrated inside the circle. Illustration: Jose-Luis Olivares/MIT (inset image courtesy of the researchers)

Study shows electrodialysis can provide cost-effective treatment of salty water from fracked wells.

David L. Chandler | MIT News Office

The boom in oil and gas produced through hydraulic fracturing, or fracking, is seen as a boon for meeting U.S. energy needs. But one byproduct of the process is millions of gallons of water that’s much saltier than seawater, after leaching salts from rocks deep below the surface.

Now researchers at MIT and in Saudi Arabia say they have found an economical solution for removing the salt from this water. The new analysis appears this week in the journal Applied Energy, in a paper co-authored by MIT professor John Lienhard, postdoc Ronan McGovern, and four others.

The method they propose for treating the “produced water” that flows from oil and gas wells throughout their operation is one that has been known for decades, but had not been considered a viable candidate for extremely high-salinity water, such as that produced from oil and gas wells. The technology, electrodialysis, “has been around for at least 50 years,” says Lienhard, the Abdul Latif Jameel Professor of Water and Food as well as director of the Center for Clean Water and Clean Energy at MIT and King Fahd University of Petroleum and Minerals (KFUPM).

The research team also included graduate student Adam Weiner, graduate student Lige Sun, and undergraduate Chester Chambers at MIT, and Professor Syed Zubair at KFUPM.

“Electrodialysis is generally thought of as being advantageous for relatively low-salinity water,” Lienhard says — such as the brackish, shallow groundwater found in many locations, generally with salinity around one-tenth that of seawater. But electrodialysis also turns out to be economically viable at the other end of the salinity spectrum, the new analysis shows.

Extra salty

Produced water from fossil-fuel wells can have salinity three to six times greater than that of seawater; the new research indicates that this salt can be effectively removed through a succession of stages of electrodialysis.

The idea would not be to purify the water sufficiently to make it potable, the researchers say. Rather, it could be cleaned up enough to enable its reuse as part of the hydraulic fracturing fluid injected in subsequent wells, significantly reducing the water needed from other sources.

Lienhard explains that if you’re trying to make pure water, electrodialysis becomes less and less efficient as the water gets less saline, because it requires that electric current flow through the water itself: Salty water conducts electricity well, but pure water does not.

McGovern, a postdoc in MIT’s Department of Mechanical Engineering and lead author of the paper, says another advantage of the proposed system is “flexibility in the amount of salt we remove. We can produce any level of output salinity.” The costs of installing an electrodialysis system, he says, appear to compare favorably to other widely used systems for dealing with produced water.

It’s not clear at this point, McGovern says, what the optimal salinity is for fracking fluids. “The big question at the moment is what salinity you should reuse the water at,” he says. “We offer a way to be able to control that concentration.”

Filtration first

Before reaching the desalination stage, the researchers envision that chemical impurities in the water would be removed using conventional filtration. One remaining uncertainty is how well the membranes used for electrodialysis would hold up following exposure to water that contains traces of oil or gas. “We need some lab-based characterization of the response,” McGovern says.

If the system works as well as this analysis suggests, it could not only provide significant savings in the amount of fresh water that needs to be diverted from agriculture, drinking water, or other uses, but it would also significantly reduce the volume of contaminated water that would need to be disposed of from these drilling sites.

“If you can close the cycle,” Lienhard says, “you can reduce or eliminate the burden of the need for fresh water.” This could be especially significant in major oil-producing areas such as Texas, which is already experiencing water scarcity, he says.

While electrodialysis technology is available now, Lienhard explains that this application would require the development of some new equipment.

Jack Gilron, who studies desalination and water treatment at Ben Gurion University in Israel and who was not involved in this research, says the team has “created an impressive demonstration of their systematic approach to analysis of [electrodialysis] performance [in] the produced water system.” However, he adds, “The authors correctly point out that the issues of scaling and organic fouling must be answered to actually put [electrodialysis] into practice for this system.”

The work was supported by KFUPM, the Hugh Hampton Young Memorial Fellowship, and the MIT Energy Initiative.

Reprinted with permission of MIT News

Ignacio Perez-Arriaga's picture

Thank Ignacio for the Post!

Energy Central contributors share their experience and insights for the benefit of other Members (like you). Please show them your appreciation by leaving a comment, 'liking' this post, or following this Member.

Discussions

No discussions yet. Start a discussion below.

Get Published - Build a Following

The Energy Central Power Industry Network is based on one core idea - power industry professionals helping each other and advancing the industry by sharing and learning from each other.

If you have an experience or insight to share or have learned something from a conference or seminar, your peers and colleagues on Energy Central want to hear about it. It's also easy to share a link to an article you've liked or an industry resource that you think would be helpful.

                 Learn more about posting on Energy Central »